| top design | aluminum rail pvc rail iron rail and 18-28-38.50 mm top rail |
| bottom rail | can match to the top rail |
| fabric desingn | blackout daylight design |
| MOQ | 10PCS for normally size |
| Packing | carton with pp bag or pet box |
| Sample | One pcs for free |

A blackout blind that goes up without a drill
These no drill roller blinds hang from a clamp bracket rather than a screw hole. The bracket grips the window frame, the wall or the ceiling, so the blind can be fitted in a rented flat, on a tiled bathroom wall or in a finished hotel room without a drill going anywhere near the surface. The chain runs down the side, and the fabric rolls up into a slim headrail when you raise it.
A conventional roller has to be drilled, plugged and patched when it comes down. This one lifts out of its brackets in seconds and leaves the opening as it was. For a contractor that means a room can be turned around between tenancies or guests without a making-good cost; for a householder it means the tile, the plaster and the frame stay intact.
As a blinds supplier we cut and assemble these window roller blinds to the measurements you send, so the bracket set is matched to the drop as well as the width. Two fabric designs sit on the same hardware: a blackout weave for rooms that need to go dark, and a daylight weave that keeps the view while it softens what comes through the glass.
It is not a tension rod and it is not an adhesive film. The clamp is a mechanical fixing that carries the roller tube, and the fabric is a woven blind with a weighted bottom bar. If the frame is shallow or the surface too soft to take a clamp, tell us before the order goes in and we will say which fixing suits instead.

A thermal roller blind works at the glass rather than in the room. The reverse of the fabric carries a silver coating that reflects radiant heat, so in winter the warmth your heating has already paid for bounces back inside instead of leaking through the pane, and in summer the same layer pushes part of the sun's heat away before it reaches the floor and the sofa.
That is why these window roller blinds belong on the window that takes the worst of the weather — a west-facing bedroom, a single-glazed landing, a shopfront that bakes from two o'clock. The effect is strongest with the blind down and close to the glass, which is what the low-profile headrail gives you.
Sun protection is the other half of the job. Lowered through the brightest hours, the cloth takes the UV hit that would otherwise land on a wooden floor, a leather armchair or a framed print on the wall. It will not stop a room warming up eventually, and we do not quote an energy-saving percentage, because the result depends on the glazing, the room and the climate — if your project needs a calculated figure, say so and we will tell you what we can supply.
One practical note: a blind sitting tight to the glass traps moisture on cold mornings. Leave it part-raised for a few minutes after cooking or showering and the condensation clears with the room.
The side-pull chain is the only control on the blind. Pull the front run and the blind climbs; pull the back run and it drops; release and the roller holds position, so it can be left at half height without creeping down through the afternoon. There is no spring to fight and no cord to lock off.
Once the no drill roller blinds are clamped in place, the chain hangs clear of the fabric at the side, which keeps the roll even and stops the cloth rubbing against the frame. Tell us at the order stage which side you want it on — left or right — and the clutch is assembled to match; on a pair of windows in the same room, put the chains on the outer edges and the two blinds read as one.
These roller shade blinds run quietly. The chain travels over a clutch rather than a bare spool, so the movement is a soft click instead of a rattle — worth having in a bedroom, a meeting room or a nursery.
Every blind ships with a chain clip. Fix it to the wall at the height of the chain's lower loop, thread the chain through it, and the loose run cannot swing free — the usual precaution wherever children or pets share the room.
On selected sizes a motorised head is available in place of the chain. Ask us whether your width and drop can take it before you put it on a whole project.
| Specification | Detail |
|---|---|
| Top rail | Aluminium, PVC or iron |
| Top rail sizes | 18, 28 and 38.5 mm |
| Bottom rail | Matched to the top rail |
| Fabric design | Blackout or daylight |
| Fabric composition | 100% polyester, with a waterproof PVC option |
| Light blocking | Up to 95% on the blackout fabric |
| Backing | Silver reflective coating |
| Colours | White, grey, beige and black, plus custom colour matching |
| Mounting | Wall or ceiling, without drilling |
| Operation | Side-pull chain, left or right |
| Sizes | Standard widths 24 in to 72 in, plus custom |
| Roller tube | Rust-proof aluminium |
Measure the width in three places — top, middle and bottom of the recess — and work to the narrowest figure, because very few windows are truly square. Measure the drop from the point where the bracket will sit, not from the top of the frame, down to the sill or to wherever you want the blind to finish. Write both numbers down and keep them; a repeat built from the same sheet will match.
Inside or outside changes both figures. An inside mount sits in the recess, the fabric is cut to the rail, and the bracket needs enough frame depth behind it to clamp. An outside mount sits on the face of the wall or on the ceiling and overlaps the opening — add a margin at each side and at the bottom, and the light at the edges drops away.
One fitting point worth settling early: in a deep reveal on an inward-opening or tilt-and-turn window, a recess-mounted blind can foul the sash when it turns. An outside mount above the reveal avoids the clash completely, and on a glazed door it is usually the only option.
We cut to your own measurements, including sizes outside the standard range. Send millimetres or inches, but send them consistently across the whole schedule — a mixed sheet is the most common source of a wrong size.
For custom roller blinds it helps to say what the blind is going over: a deep reveal, a tiled bathroom wall, a door with a frame that stands proud. We will come back with the rail and bracket that suit rather than a generic size. Allow a small tolerance at the fabric edge as well — a roller is cut and rolled by hand and needs a little clearance to run without rubbing, so flag a tight opening and we will allow for it.
Every blind ships with the mounting hardware you need — brackets, screws, and an instruction manual — and fits most standard windows. Choose an inside or outside mount; installation takes 15 minutes or less and needs no professional skills.
Choose from 12+ neutral colors, including white, gray, beige, and black, in multiple widths from 24" to 72". The minimalist lines suit modern, industrial, rustic, or traditional decor and blend seamlessly with your furniture and walls.
Meijia Window Decoration has been manufacturing window coverings since 2005 and today runs a 53,000 m² factory with around 200 staff, plus a second production base in Anhui with 12 lines, backed by a database of more than 3,000 qualified suppliers. We supply builders, e-commerce sellers and supermarkets across Europe, North and South America, the Middle East and Asia, with OEM and private-label production, minor customisation and one-stop export handling under 100% quality control. Both plants hold BSCI social responsibility, ISO 9001 and ISO 14001 certification.
No roller blind stops every photon, and we would rather say so up front. The blackout weave blocks up to 95% of the light that reaches it, so a bedroom goes properly dark and a projector image stays clean, but a thin line still creeps past the fabric edge and under the bottom bar. An outside mount that overlaps the recess narrows that line; a blackout lining behind a curtain closes it completely.
A flat, solid edge of adequate depth. Timber and uPVC frames, tiled walls, a sound plastered reveal and a ceiling with something solid behind it all take the clamp; a soft, crumbling or heavily textured surface does not, and neither does a frame too shallow for the bracket to grip. Send us a close-up of the fixing point with your enquiry and we will tell you before the order goes in rather than after.
The rail comes in three sizes, in aluminium, PVC or iron. As a rule of thumb, the narrowest suits a bathroom or door window, the middle size covers most domestic widths, and the largest is for a wide or tall blind where there is more cloth weight to carry and less tolerance for sag. The bottom bar is matched to whatever you pick. Give us the width and drop and we will recommend.
The blackout cloth is dense and opaque: it takes a room down to near-dark and keeps it private at night. The daylight cloth is a more open weave that scatters hard sun into soft light and lets you see out — the light view option. Same rail, same brackets, same chain; the choice is about the room rather than the hardware, so it is worth settling per room on a multi-window job.
Usually yes, but the mount has to move. A recess-mounted blind in a deep reveal can foul an inward-opening or tilt-and-turn sash when it swings. Fit it outside the reveal, on the wall or the ceiling above the opening, and the blind clears the sash and still covers the glass. On a glazed door the ceiling mount is normally the only workable position.
Dust with a soft brush or a vacuum brush attachment on low, then wipe with a damp cloth and a little mild soap where something has marked it. Do not scrub, do not use bleach or an abrasive pad, and never put roller shade blinds in a washing machine. The PVC option takes the same treatment and shrugs off kitchen splashes. Leave the blind down until the cloth is dry before rolling it back up.
Yes. We cut to your measurements, including sizes outside the standard range. Send the width, the drop, the mounting point (wall, ceiling or recess), the chain side and the fabric design, and we will confirm the rail and bracket that suit. For custom roller blinds across a whole building, send the full schedule at once so the batch is cut together and the colour holds across every room.